Tachometer; Fuel Gauge - Subaru 2006 Legacy Owner's Manual

3-12
Instruments and controls
Vehicle communication system
fault indication
The vehicle communication system car-
ries various types of information (vehicle
speed, running conditions, etc.) to control
modules. In the event of a fault in this
communication system, the trip meter will
show " ".
If the trip meter shows "
ly contact the nearest SUBARU dealer
and have the vehicle communication sys-
tem inspected.
NOTE
If you press the trip knob while the trip
meter is showing " ", the trip meter
indication will appear for 10 seconds.

Tachometer

The tachometer shows the engine speed
in thousands of revolutions per minute.
Do not operate the engine with the
pointer of the tachometer in the red
zone. In this range, fuel injection will
be cut by the engine control module
to protect the engine from overrev-
ving. The engine will resume run-
", immediate-
ning normally after the engine
speed is reduced below the red
zone.
NOTE (3.0-liter models only)
To protect the engine while the "P" or
"N" position is selected, the engine is
controlled such that the engine speed
does not become too high even if the
accelerator pedal is pressed hard.

Fuel gauge

The fuel gauge shows the approximate
amount of fuel remaining in the tank.
The gauge does not return to "E" even
though the ignition switch is in the "ACC"
or "LOCK" position.
The gauge may move slightly during brak-
ing, turning or acceleration due to fuel lev-
el movement in the tank.
If you press the trip knob while the ignition
switch is in the "LOCK" position, the fuel
gauge's dial will light up and the needle
will indicate the amount of fuel remaining
in the tank.
If, while the fuel gauge needle is indicating
the amount of fuel remaining in the tank,
you (a) do not press the trip knob for 10
seconds or (b) open and close the driver's
300640