Replacement Of Windshield Wiper Blades - Subaru 2003 Legacy Owner's Manual

Hide thumbs Also See for 2003 Legacy:
Table of Contents

Advertisement

Washer Fluid Concentration
30%
50%
100%

Replacement of windshield wiper blades

Grease, wax, insects, or other materials on the windshield or the wiper
blade results in jerky wiper operation and streaking on the glass. If you
cannot remove the streaks after operating the windshield washer or if the
wiper operation is jerky, clean the outer surface of the windshield (or rear
window) and the wiper blades using a sponge or soft cloth with a neutral
detergent or mild-abrasive cleaner. After cleaning, rinse the windshield
and wiper blades with clean water. The windshield is clean if beads do
not form when you rinse the windshield with water.
CAUTION
Do not clean the wiper blades with gasoline or a solvent, such as
paint thinner or benzene. This will cause deterioration of the
wiper blades.
If you cannot eliminate the streaking even after following this method,
replace the wiper blades using the following procedures:
11-48
Freezing Temperature
10.4 F (–12 C)
–4 F (–20 C)
–49 F (–45 C)
HBB004IA

Advertisement

Table of Contents
loading

This manual is also suitable for:

2003 outback

Table of Contents