Subaru 2003 Legacy Owner's Manual page 213

B FM/AM selection button
Press the "FM/AM" selection button
broadcasts. The display will show FM or AM accordingly.
Use the tuning dial to select the station to which you wish to listen.
B Manual tuning
Turn the tuning dial
tion frequency in individual steps.
FM band: 0.2 MHz steps
AM band: 10 kHz steps
B Seek tuning (SEEK)
3
If the Tuning dial
cond, the radio will begin to automatically search for receivable fre-
quencies and will stop at the first one found. This function may not be
available, however, when radio signals are weak. In such a situation,
perform manual tuning to select the desired station.
B Scan tuning (SCAN)
Press the "SCAN" button
this mode, the radio scans through the radio band until a station is
found. The radio will stop at the station for five seconds while display-
ing the frequency, after which scanning will continue until the entire
band has been scanned.
Turn the tuning dial
and to stop on any displayed frequency.
Scan tuning may not function properly if the station reception is weak-
ened by distance from the station or proximity to tall buildings and
hills.
B Preset tuning
Press any one of the preset buttons
previously-registered radio station. The LED at the top of that button
will turn on.
n Manual preset
D Use the tuning dial
register.
1
3
outer tuner to increase or decrease the recep-
outer tuner is turned for longer than half of a se-
4
to change the radio to the SCAN mode. In
3
inner tuner again to cancel the SCAN mode
5
3
to select the radio station which you wish to
to choose either FM or AM
to select the corresponding,
– CONTINUED –
Audio
5
5-29