Technical Details; Safety Devices; Warning Symbols; Installation - CAMPAGNOLA POWER 58 Use And Maintenance Manual

11
Telescopic extension pole
12
Fixed extension pole
13
Power supply cable connector
14
13 m power supply cable
15 1.5 m power supply cable
16
Speed selector led lights
3.6

Technical details

• Power unit weight:
• Motor rotation speed I:
• Motor rotation speed II:
• Motor rotation speed III:
3.7

Safety devices

• Built-in safety device: stops the tool automatically in case of motor overheating.
• ON/OFF Led light (9): indicates the tool is working.
• Poles inversion protection in connection with the lead battery.
• Min. and max. lithium battery voltage: 10V – 14V
3.8

Warning symbols

General warning
Duty of reading the use
& maintenance manual
Compulsory head protection

4 INSTALLATION

4.1

Start-up

• Remove the power unit (1) and the cable (14-15) from their box.
• Assemble the power unit onto the extension pole with the chosen harvesting head. Insert the shaft (10) and tighten the
screws (2) of the clamp connection (3).
• Insert the power supply cable (14-15) into the handgrip hole.
• Join the power supply cable (14-15) with the connector (4) taking care of the male and female connections. Use the
antierror device for the proper connectors insertion.
• Start the tool by means of the ON/OFF switch (7) and check the led light (9) is on.
4.2

Selection and variation of the speed

On the ON/OFF switching sticker press the button (8) to select the motor speed: position I: 1080 rpm, position II: 1150
rpm, position III: 1180 rpm.
4.3

Procedure for setting/unsetting the power saver function

• Connect the power unit to the battery
• Do not start the tool, keep the speed selector (8) pressed for 5 sec., until the ON red led light (9) flashes confirming the
operation.
• Start the tool with the power saver function inserted. The speed selector LED light (16) flashes.
• To unset the power saver funcion, keep the speed selector (8) pressed for 5 sec,. until the ON red light (9) flashes,
confirming the operation.
Use and Maintenance Manual – Original
Instructions Rev.: 02, Data 11/02/2021
Holds the tool
Holds the tool
Connects the power unit with the power supply cable
Connects the power unit with the lead battery
Connects the power unit with the lithium battery
Indicate the selected speed
850 g
1080 ± 20 rpm (1 red Led on)
1150 ± 20 rpm (1 red Led on)
1180 ± 20 rpm (2 red Led on)
Compulsory adequate clothing
Compulsory hands protection
Compulsory feet protection
C-D
C-D
C-E
C-E
G
B
Pag. 23