Installing Handles - QNAP TS-431XeU User Manual

7. Attach the case cover.
a. Slide the case cover down until it completely connects with the chassis.
b. Attach the screws that secure the case cover to the chassis.
8. Connect all cables and external attachments.
9. Power on the NAS.
10. Verify that the module is recognized by the NAS.
a. Log on to QTS as administrator.
b. Go to Control Panel > System > System Status > Hardware Information .
c. Check the value for Total memory.

Installing Handles

Installing handles enables you to better grip and further secure the NAS on a rack.
1. Power off the NAS.
2. Install a handle to an angle bracket.
a. Align the openings of the handle with the two round screw holes on the angle bracket.
b. Attach the screws to lock the handle to the angle bracket.
3. Install the angle bracket on the NAS.
a. Align the holes on the angle bracket with the holes on the left side of the chassis.
Note
Ensure that the handle faces the same direction as the front panel.
b. Attach the screws to lock the angle bracket to the chassis.
TS-431XeU User Guide
Installation and Configuration 19