Telephone Base And Charger Installation - AT&T EL52119 User Manual

Getting started

Telephone base and charger installation

Install the telephone base and charger, as shown below. If you subscribe
to high-speed Internet service (DSL - digital subscriber line) through your
telephone line, you must install a DSL filter between the telephone line cord
and the telephone wall jack. The filter prevents noise and caller ID problems
caused by DSL interference. Please contact your DSL service provider for
more information about DSL filters.
The telephone base is ready for tabletop use. If you want to mount your
telephone on a wall, see Wall-mount installation on page 11 for details.
Route the cords
through the slots.
Plug the small
end of the
base power
adapter into
the power
jack on the
bottom
of the
telephone
base.
Plug the large end of the
charger's power adapter
into an electrical outlet not
controlled by a wall switch.
Ensure the small end of the charger's
power adapter is plugged into the power
jack on the bottom of the charger.
Plug the large end of the base power
adapter into an electrical outlet not
controlled by a wall switch.
Plug the other end
of the telephone
line cord into the
telephone line jack
on the bottom of
the telephone base.
IMPORTANT INFORMATION
Use only the power adapter(s) supplied
with this product. To order a replacement
power adapter, visit our website at
https://telephones.att.com
1 (800) 222-3111
call
1 (866) 288-4268
7
Plug one end of the
telephone line cord into a
telephone wall jack.
A DSL filter (not
included) is
required if you
have DSL high-
speed Internet
service.
Raise the antenna.
. In Canada, dial
.
or