Installation Install the telephone base close to a telephone jack and a power outlet not controlled by a wall switch. For optimum range and better reception, place the telephone base in a central and open location. If you subscribe to high-speed Internet service (digital subscriber line - DSL) through your telephone lines, you must install a DSL filter between the telephone line cord and the telephone wall jack (see the following page).
Battery installation & charging Install the battery as shown on the next page. Once you have installed the battery, the screen indicates the battery status (see table below). If necessary, place the handset in the telephone base to charge the battery. For best performance, keep the handset in the telephone base when not in use.
Page 4
Battery installation & charging CHARGE light Step Step Step Plug the battery Charge the handset by Align the cover flat connector securely placing it face up in the against the battery into the socket inside telephone base. The compartment the handset battery CHARGE light will be...
Telephone base installation Install the telephone as shown below. The telephone base is ready for table use. 5. Plug the other end of the If you have DSL high telephone line speed Internet service, a DSL filter (not included) cord into a is required.
Quick reference guide - handset qCID / VOLUME CHARGE light qCID Press to show caller ID The charge light is on when the information when the phone is handset is charging (page ). not in use. Press to scroll down while in pDIR / VOLUME menus.
Quick reference guide - telephone base VOICEMAIL indicator IN USE indicator Flashes when you have On when the handset is in new voicemail. Voicemail use or when the answering service is offered by your system is answering an local telephone service incoming call.