Test Feeding Mode - Brother HE-800C Instruction Manual

6. USING THE SEWING MACHINE (SEWING OPERATION)
3
Place the material under the work clamp, and then depress the treadle (5) to the 1st step (B).
4
Depress the treadle (5) to the 2nd step (C).
4819M
5
To repeat the sewing operation, repeat steps 3 and 4 above.

6-2. Test feeding mode

This mode lets you check needle zigzag, work clamp and length feed plate movement in the sewing pattern which has been
programmed without actually sewing the program.
(The needle will not move up and down and the cutter will not operate either.)
1
Switch the mode to test feeding mode.
4210B
2
Select the program number (2) for test feeding.
4787M
49
The work clamp will drop.
Sewing will then start.
* When sewing is complete, the work clamp will
rise.
The sewing pattern (1), the program number (2) and the number of
stitches (3) will appear in the display.
Independent program
(Refer to P. 33)
The program number (2) changes in the order shown in the
illustration each time the
(The key changes the order in the opposite direction.)
HE-800C
Cycle program
(Refer to P. 53)
key is pressed.
4818M
4820M
4821M