Table of Contents
Advertisement
Charging the built-in battery
The date/time set in the camera is maintained by the built-in battery.
The built-in battery has been consumed when [BACKUP BATT EMPTY] is displayed in the viewfinder or LCD monitor for approximately five seconds
when the power switch is set to <ON>.
Charge the built-in battery with the following procedure.
1
Make sure that the power switch is <OFF>.
2
Connect the AC adaptor to the camera.
For details on the connection of AC adaptor, refer to "Using the AC adaptor" (page 29).
3
Leave the camera for approx. four hours.
The built-in battery will be charged.
After charging completes, set the date and time and check the time code. If [SET DATE AND TIME] is displayed on the viewfinder or LCD monitor,
set the date/time of the internal clock. (page 36)
4
Set the power switch to <ON>, and check that [BACKUP BATT EMPTY] is not displayed in the viewfinder screen.
If [BACKUP BATT EMPTY] is still displayed after charging, the built-in battery needs to be replaced. Consult your dealer.
Chapter 3 Preparation — Charging the built-in battery
– 35 –
Advertisement
Table of Contents
