Table of Contents
Advertisement
Item
[SDI EDH]
[HD SDI REMOTE]
[DOWNCON MODE]
[DOWNCON SETTING]
[DETAIL]
[H.DTL LEVEL]
[V.DTL LEVEL]
[DTL CORING]
[H.DTL FREQ]
[USB SETUP]
Configures the settings for switching the USB mode.
Item
[USB MODE]
[DISPLAY SETUP]
Configure the settings regarding the details to be displayed on the viewfinder or LCD monitor.
These menu items cannot be set when the thumbnail screen is displayed.
Item
[MENU DISPLAY]
[ZEBRA1 DETECT]
[ZEBRA2 DETECT]
[ZEBRA2]
[CENTER MARK]
[SAFETY MARK]
Chapter 6 Menu Operations — Menu list
Selects whether to superimpose EDH when output from the <SDI OUT> terminal is SD signal (480i and
576i).
[ON]: Superimposes.
[OFF]: Does not superimpose.
f Factory setting: [ON]
Sets whether to use the control function of recording operation for an external device (such as a recorder)
connected to the <SDI OUT> terminal at HD SDI output.
[ON]: Controls the recording operation of the external device.
[OFF]: Does not control the recording operation of the external device.
f Factory setting: [OFF]
Selects the mode of the down convertor output signal from the <SDI OUT> terminal when it is in the HD
mode (1080P, 1080i, or 720P).
[SIDE CROP], [LETTER BOX], [SQUEEZE]
f Factory setting: [LETTER BOX]
Turns detail function for the down converter output signal [ON]/[OFF].
[ON], [OFF]
The down converter output signal contains detail components set during HD signal processing.
This setting superimposes the detail components exclusive to down converter output to that signal.
f Factory setting: [ON]
Sets horizontal detail correction level for the down converter output signal.
[0]...[31]
f Factory setting: [8]
Sets vertical detail correction level for the down converter output signal.
[0]...[31]
f Factory setting: [4]
Sets the detail noise removal level.
[0]...[15]
f Factory setting: [1]
Selects the horizontal detail frequency.
[2.5MHz], [3MHz], [3.5MHz], [4MHz], [4.5MHz]
f Factory setting: [3.5MHz]
Switches the enable/disable of the USB mode.
[ON], [OFF]
f Factory setting: [OFF]
Selects the LCD monitor or the view finder as the location where the menu is displayed.
[LCD&EVF]: Displays the menu both on the LCD monitor and the viewfinder.
[LCD]: Displays the menu only on the LCD monitor.
f Factory setting: [LCD&EVF]
Sets the extraction level of zebra pattern 1.
[0%]...[109%]
f Factory setting: [70%]
Sets the extraction level of zebra pattern 2.
[0%]...[109%]
f Factory setting: [85%]
Sets on/off of zebra pattern 2 and selects the type.
[ON], [SPOT], [OFF]
f Factory setting: [SPOT]
Controls the center mark.
[1]: + (large)
[2]: Open center (large)
[3]: + (small)
[4]: Open center (small)
[OFF]: Does not display.
f Factory setting: [1]
Selects the type of frame for the safety zone marker.
[1]: Box
[2]: Corners
[OFF]: Does not display.
f Factory setting: [2]
– 135 –
Description of settings
Description of settings
Description of settings
Advertisement
Table of Contents
