Charging The Built-In Battery/Setting The Time Code; Recharging The Built-In Battery; Setting The Time Code; Specifying The Time Code (Tc Preset) - Panasonic AVCCAM AG-AF101A Operating Instructions Manual

Charging the built-in battery/Setting the time code

Recharging the built-in battery

The camera's internal battery saves the date and
time.
When LOW INTERNAL BATTERY (indicating that
the internal battery has no remaining charge) is
displayed even when the date and time are set,
it means that the charge of the internal battery is
depleted. Do the following to recharge it.
Reset the date and time when fully recharged.
1
Connect the AC adaptor. (Page E-25 of Vol.1)
• Leave the POWER switch at OFF.
2
Leave the camera-recorder like this for
about 4 hours.
• The internal battery charges during this time.
• Check the time code and menu operations
after recharging.
If the date and time are not memorized after
recharging, the internal battery requires changing.
Please consult the place of purchase.

Setting the time code

In the setup menus, TC/UB SETUP screen, set the
following time code related items. (Page 57)
• TC MODE
• TCG
• TC PRESET
Specifying the time code
(TC PRESET)
Set TC PRESET so you can record a value of your
choice as the initial setting for the time code to be
used at the start of recording.
1
Set the POWER switch to ON.
2
Select the TC PRESET item in the settings
menu TC/UB SETUP screen.
• For menu operation (Page E-44 of Vol.1)
• Operations may also be performed
using buttons on the remote control that
correspond to those on the camera. For
details, see "Description of parts (Remote
control)". (Page E-23 of Vol.1)
3
Tilt the Operation lever in the
move to YES, and push the Operation lever.
direction to
25