Texas Memory Systems RamSan-120 User Manual page 86

Table 1 describes the SNMP default configuration:
Feature:
SNMP Community Strings:
SNMP Trap IPs:
SNMP Traps:
In addition, the SNMP standards allow you to enter the location of the
system (i.e. "Row 11, Rack C") and specify an administrative contact for
the system (i.e. "Pat Smith, (713) 555-1212").
The following sections demonstrate how to change the default SNMP
strings. Changing these values causes the RamSan to use the new string
when sending SNMP messages.
Via Text Management
•
•
Figure 8-1: SNMP Configuration via Text Management Interface
The top of this menu displays the current SNMP settings.
To change the read community name:
•
•
To change the read/write community name:
•
•
RamSan-120 User's Manual
Table 1: SNMP Default Configuration
From the Telnet Main Menu, select "Management setup"
Select "Configure SNMP"
Select "Change read community name"
Enter the read community name and press [ENTER]
Select "Change read/write community name"
Enter the read/write community name and press [ENTER]
Default Setting:
Read:
Read/Write:
System Location:
System Contact:
None configured
None enabled
Read
ReadWrite
Nothing
Nothing
- 82 -