TABLE OF CONTENTS INTRODUCTION .................................. 3 ABOUT THIS MANUAL ..............................3 ABOUT TWN4 PALON SQUARE M LF HF ........................3 ELATEC SUPPORT ................................3 REVISION HISTORY ..............................3 SAFETY INFORMATION ..............................3 INTEGRATION INSTRUCTIONS ............................4 GENERAL ..................................4 LIST OF APPLICABLE RULES ............................4 SPECIFIC OPERATIONAL USE CONDITIONS ......................4 LIMITED MODULE PROCEDURES ..........................4...
• Before installing TWN4 Palon Square M LF HF into a host device, the integrator should also make sure that he/she has read and understood the ELATEC technical documentation related to TWN4 Palon Square M LF HF, as well as the technical documentation related to the host device.
GENERAL TWN4 Palon Square M LF HF may be installed in any host devices, as long as it is operated under the operational conditions stated in the user manual and other technical documents (e.g. data sheet). TWN4 Palon Square M LF HF is equipped with two integrated antennas.
No specific testing method has been defined by ELATEC for TWN4 Palon Square M LF HF. TWN4 Palon Square M LF HF has been tested and found in compliance with the specifications noted on the approval certificates and other relevant approval documents. However, the integrator is still responsible for any additional testing and authorization process required for the end product.
4 COMPLIANCE STATEMENTS TWN4 Palon Square M LF HF is in compliance with the EU directives and regulations as listed in the respective declaration of conformity. RF EXPOSURE COMPLIANCE RF exposure statement (mobile and fixed devices) This device complies with the RF exposure requirements for mobile and fixed devices. However, the device shall be used in such a manner that the potential for human contact during normal operation is minimized.
Page 8
Elatec reserves the right to change any information or data in this document without prior notice. Elatec declines all responsibility for the use of this product with any other specification but the one mentioned above. Any additional requirement for a specific customer application has to be validated by the customer himself at his own responsibility. Where application information is given, it is only advisory and does not form part of the specification.
Need help?
Do you have a question about the TWN4 PALON SQUARE M LF HF and is the answer not in the manual?
Questions and answers