Elatec TWN4 Palon Square M LF HF Integration Manual

Elatec TWN4 Palon Square M LF HF Integration Manual

Hide thumbs Also See for TWN4 Palon Square M LF HF:

Advertisement

Quick Links

TWN4 Palon Square M
LF HF
INTEGRATION MANUAL

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the TWN4 Palon Square M LF HF and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Elatec TWN4 Palon Square M LF HF

  • Page 1 TWN4 Palon Square M LF HF INTEGRATION MANUAL...
  • Page 2: Table Of Contents

    TABLE OF CONTENTS INTRODUCTION ................................3 ABOUT THIS MANUAL ............................3 ELATEC SUPPORT ..............................3 SAFETY INFORMATION ............................4 INTEGRATION INSTRUCTIONS ..........................6 GENERAL ................................... 6 LIST OF APPLICABLE RULES..........................6 SPECIFIC OPERATIONAL USE CONDITIONS ..................... 6 LIMITED MODULE PROCEDURES ........................6 TRACE ANTENNA DESIGN ..........................
  • Page 3: Introduction

    In case of any technical questions or product malfunction, refer to the ELATEC website (www.elatec.com) or contact ELATEC technical support at support-rfid@elatec.com © 2024 – ELATEC GmbH – TWN4 Palon Square M LF HF – integration manual – DocRev03 – EN – 05/2024 Page 3 of 11...
  • Page 4: Safety Information

    Before installing the product into the host device, the power supply of the host device must be turned off. © 2024 – ELATEC GmbH – TWN4 Palon Square M LF HF – integration manual – DocRev03 – EN – 05/2024 Page 4 of 11...
  • Page 5 Any failure to comply with the safety information given in this document is considered improper use. ELATEC excludes any liability in case of improper use or faulty product installation. © 2024 – ELATEC GmbH – TWN4 Palon Square M LF HF – integration manual – DocRev03 – EN – 05/2024 Page 5 of 11...
  • Page 6: Integration Instructions

    3 INTEGRATION INSTRUCTIONS GENERAL TWN4 Palon Square M LF HF may be installed into any host device, as long as it is operated under the operational conditions stated in the product user manual and other technical documents (e.g. data sheet). The product is equipped with 2 integrated RFID antennas. Thus, no antenna installation is required.
  • Page 7: Label And Compliance Information

    TWN4 Palon Square M LF HF. 3.11 ELECTRICAL CONNECTION © 2024 – ELATEC GmbH – TWN4 Palon Square M LF HF – integration manual – DocRev03 – EN – 05/2024 Page 7 of 11...
  • Page 8: Programmation/Software Integration

    N.C. reserved, do not connect RS-485 B N.C. reserved, do not connect 3.12 PROGRAMMATION/SOFTWARE INTEGRATION © 2024 – ELATEC GmbH – TWN4 Palon Square M LF HF – integration manual – DocRev03 – EN – 05/2024 Page 8 of 11...
  • Page 9: Integrator And Host Requirements

    If additional filing is required, please contact the person at ELATEC GmbH responsible for certification of the RF module. © 2024 – ELATEC GmbH – TWN4 Palon Square M LF HF – integration manual – DocRev03 – EN – 05/2024 Page 9 of 11...
  • Page 10: Appendix

    “Compliance Statements” deleted Chapters “About this Manual”, “Safety Information” and 02/2022 “Compliance Statements” updated First edition 09/2021 © 2024 – ELATEC GmbH – TWN4 Palon Square M LF HF – integration manual – DocRev03 – EN – 05/2024 Page 10 of 11...
  • Page 11 ELATEC reserves the right to change any information or data in this document without prior notice. ELATEC declines all responsibility for the use of this product with any other specification but the one mentioned above. Any additional requirement for a specific customer application has to be validated by the customer themselves at their own responsibility.

Table of Contents