Ironing With The Brush Attachment - Silvercrest SDRB 1000 C1 Operating Instructions Manual

__NAS279803_Dampfbuerste_B5.book Seite 45 Donnerstag, 23. Juni 2016 10:35 10
3. Press the steam jet button 11 while the
steam brush slides over the item of
laundry. It may be necessary to press
repeatedly to trigger the first jet of
steam.
4. After triggering the first jet of steam,
please wait a few seconds before press-
ing the steam jet button 11 again. You
should only press the steam jet button 11
repeatedly until the control lamp 7 lights
up or water drips out of the sole
plate 14. Please wait for the control
lamp 7 to go off before triggering anoth-
er jet of steam.
6.5 Ironing with the brush
attachment
DANGER! Risk of injury
through burning!
Please wait until the device has cooled
down before you attach and remove the
brush attachment 17.
Never iron or remove creases from
clothes while they are being worn.
Allow the item of clothing to cool down
on a hanger before you wear it.
Attaching the brush attachment
• Figure B: push the brush attach-
ment 17 along the guide groove on the
sole plate 14 until it reaches the stop
position on the device. The unlocking
mechanism 16 of the brush attach-
ment 17 must be heard to lock into
place.
Removing the brush attachment
• Figure B: press down the unlocking
mechanism 16 of the brush attach-
ment 17 and pull the brush attach-
ment 17 off towards the front at the
same time.
Caring for your garments
1. Hang the creased garment up on a
hanger.
2. Pull the garment flat with one hand, ap-
plying the steam from top to bottom.
Apply slight pressure with the clothes
brush 19 and move the device from
top to bottom across the garment. At
the same time you can press the steam
jet button 11 at short intervals. The
combination of steam and clothes
brush 19 gently removes all of the
creases.
Caring for curtains and uphol-
stery
1. Remove creases and wrinkles from dra-
pery by hanging them over a rail.
2. Follow the instructions under "Caring
for your garments".
3. Always carry out a test beforehand on
a spot which is not visible.
4. If you use the device horizontally, hold
it vertically from time to time in order to
obtain the maximum steam power.
Removing lint
• Threads, lint and hairs can be easily re-
moved with the lint brush 18 by brush-
ing slowly from right to left across the
garment.
• You can clean the lint brush 18 by
brushing in the opposite direction (from
left to right), e.g. across remnants of ma-
terial.
45
GB