Stihl FS 360 C-M Instruction Manual page 31

Using the tool
If the tool is put into operation for the first
time, then observe the notes "First start-
up" in the section "Further notes on
starting".
If the engine has been started in the
N
start position}: Simultaneously
press briefly the throttle trigger
lockout and the throttle trigger; the
choke lever jumps to operating
positionF and the engine begins to
idle
The machine is now ready for use.
WARNING
In the position for operationFand
simultaneous engine idling, the cutting
attachment must not rotate!
If the cutting attachment rotates when
the engine is idling, follow the
instructions in the chapter "Adjusting the
throttle cable" or have the tool repaired
by a specialist dealer. STIHL
recommends STIHL servicing dealers.
Connecting machine to harness
N
Using the tool
N
FS 360 C-M, FS 410 C-M, FS 460 C-M, FS 490 C-M
Switching off engine
Press stop switch – the engine
N
stops – release stop switch – the
stop switch returns to its original
position
Further notes on starting
First start-up
Press throttle trigger – do not
N
actuate throttle trigger lockout
If the engine speed increases or if the
cutting attachment turns too, then:
continue in section "Switching off
N
engine"
continue in chapter "Setting the
N
throttle cable"
If there is no higher speed, the tool is
ready for operation.
At very low temperatures
If necessary, convert engine to
N
winter operation, see "Winter
operation"
If the power tool has cooled down
N
considerably (frost formation), after
starting let the engine warm up in
the start position} and bring it to
operating temperature - Attention:
the cutting attachment will rotate!
The engine does not fire
Check whether all the controls are
N
set correctly
Check whether there is fuel in the
N
tank and refuel if necessary
Check whether the spark plug boot
N
is connected securely
Repeat the starting procedure
N
The engine is flooded
Set choke lever to F – continue
N
cranking until the engine runs
If the tank has been drained completely
After refueling, press the manual
N
fuel pump bulb at least five times –
even if it is full of fuel.
Restart the engine
N
English
29