U-Line H-1941 Assembly Instructions Manual

π
ROLLING LADDER –
11-16 STEPS

TOOLS NEEDED

9/16" Wrench 9/16" Socket Wrench
Two people required
for assembly
NOTE: Upon receipt of the unit, check ladder
and bracing for any visible defects or shipping
damage.
CAUTION! Do not set up ladder if there is any
visible damage. Note any damage on waybill
and contact Uline Customer Service.
1. Position ladder on its side on the floor. (See Figure 1)
2. Locate the loose bracing strapped to the unit.
Remove and set aside.
3. Separate the bracing into pairs. Using the bolts
provided, attach bracing to remaining lugs.
NOTE: Install bottom bracing first.
4. Securely fasten bolts.
5. Using two people, grab handrails closest to floor
and push up until ladder has come to rest on all
wheels. (See Figure 2)
6. Ensure ladder is level.
CAUTION! If ladder is not level, loosen bolts
slightly, allow ladder to settle and re-tighten bolts.
7. Inspect all bolted connections and wheel
assemblies to ensure proper assembly. For units with
a top step greater than 10', a competent person
must inspect the assembly prior to putting it into
service.
PAGE 1 OF 6
1-800-295-5510
uline.ca
ASSEMBLY INSTRUCTIONS
Figure 1
Figure 2
Para Español, vea páginas 3-4.
Pour le français, consulter les pages 5-6.
0721 IH-1941