Reprogramming A Single Homelink Button; Security - Jeep 2007 Grand Cherokee Series Owner's Manual

152 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
• Press and hold the two outer HomeLink buttons and
release only when the EVIC display shows "CHAN-
NELS CLEARED" (after 20 seconds). Release both
buttons. Do not hold for longer that 30 seconds.
HomeLink is now in the train (or learning) mode and
can be programmed at any time beginning with Pro-
gramming - Step 2.

Reprogramming a Single HomeLink Button

To program a device to HomeLink using a HomeLink
button previously trained, follow these steps:
1. Press and hold the desired HomeLink button. Do
NOT release the button.
2. The EVIC display will show "CHANNEL X TRANS-
MIT" (where X is Channel 1, 2, or 3) for 20 seconds and
then change to "CHANNEL X TRAINING." Without
releasing the HomeLink button, proceed with Program-
ming Step 2.
For questions or comments, contact HomeLink at:
www.homelink.com or 1-800-355-3515.

Security

If you sell your vehicle, be sure to erase the frequencies
by following the "Erasing HomeLink Buttons" instruc-
tions in this section.
This device complies with part 15 of FCC rules and with
RSS-210 of Industry Canada. Operation is subject to the
following conditions:
• This device may not cause harmful interference.
• This device must accept any interference that may be
received including interference that may cause undes-
ired operation.
NOTE: Changes or modifications not expressly ap-
proved by the party responsible for compliance could
void the user's authority to operate the equipment.