Hyundai 2007 Tiburon Owner's Manual page 180

D060E01A-AAT
4. Put the Jack in Place
The base of the jack should be placed
on firm, level ground. The jack should
be positioned as shown in the drawing.
D060F02E-AAT
5. Raising the Car
OGK036401
After inserting a bar into the wheel nut
wrench, install the bar into the jack as
shown in the drawing. To raise the
vehicle, turn the jack handle clockwise.
As the jack begins to raise the vehicle,
double check that it is properly posi-
tioned and will not slip. If the jack is on
soft ground or sand, place a board,
brick, flat stone or other object under
the base of the jack to keep it from
sinking.
Raise the car high enough so that the
fully inflated spare tire can be installed.
To do this, you will need more ground
clearance than is required to remove
the flat tire.
Wrench bar
Do not get under the car when it is
supported by the jack! This is very
dangerous as the jack could fall and
Wheel nut
wrench
cause serious injury or death. No
D060F01MC
one should stay in the car while the
jack is being used.
WHAT TO DO IN AN EMERGENCY
!
WARNING:
3
13