Threading End And Unthreading End States - Sony BVW-55 Maintenance Manual

3-1-3. Threading End and Unthreading End States

1. Threading end state
In the threading end state, the S and T sliders move from the reel table side to both sides of the drum and
the pins of the S and T sliders stop in the V grooves of each catcher. At the same time, the S tension
regulator arm, T3 guide, pinch roller, and T tension regulator arm move to the positions shown in the
figure.
Pin
S slider
S tension regulator arm
To enter the threading end state using tape
(1) Turn on the power.
(2) Insert a cassette tape into the cassette compartment.
(3) Close the control panel or cassette compartment.
To enter the threading end state manually
Turn the manual eject knob clockwise.
n
Stop the rotation of the manual eject knob if the mechanical deck is in the above mentioned threading end
state. If not, the related gears may be damaged.
BVW-55 P2
http://getMANUAL.com
S catcher T catcher
3-1. General Information on Parts Replacement and Alignment
Pin T slider
T3 guide (T drawer guide)
Manual eject knob
Pinch roller
T tension regulator arm
3-3