Table of Contents
Advertisement
2-1. Overview of Maintenance Mode
This unit has the maintenance mode that is useful during
maintenance and trouble diagnosis.
This maintenance mode consists of the four modes below.
The contents of the maintenance mode are superimposed
on the LCD monitor and the video monitor connected to
the VIDEO OUTPUT 2 (SUPER) connector.
To superimpose the contents of the maintenance mode, set
the SUPER item on the general setting page of the sub
LCD menu to ON. (For the sub LCD menu. refer to the
operation manual.)
This section does not explain about items which is de-
scribed in the maintenance manual part 1.
M0 : TAPE MAINTENANCE ............. (Section 2-2)
This mode is used for maintenance of a VTR part.
In this manual, explains tape maintenance items for
adjustment only.
M2 : ERROR LOGGER
This mode is used to display the record of errors (error
logging) that occur in this unit.
M3 : OTHERS ................................... (Section 2-3)
This mode is used for checking the others.
M4 : SETUP MAINTENANCE
This mode is used for the setup menu.
BVW-55 P2
Section 2
Maintenance Mode
MAINTENANCE MODE
*
M0 : TAPE MAINTENANCE
M2 : ERROR LOGGER
M3 : OTHERS
M4 : SETUP MAINTENANCE
(Mode screen during activation of maintenance mode)
TAPE MAINTENANCE MODE
*
C0 :
C2 : AUDIO/VIDEO
A0 :
A1 : BETACAM REC ADJUST
A2 : AUDIO/VIDEO ADJUST
A3 : BETACAM PB
A4 : MECHANISM
ERROR LOGGER
(001/003)
*
001 REEL TROUBLE-1
002 TAPE TENSION ERROR
003 INTERNAL I/F ERROR
------------------------
TAPE ERROR
WARNING
CONDITION
'97 09 03
M3:OTHERS
*
M30:ROM VERSION
M31:SERIAL NUMBER
M35:MEMORY CHECK
M36:HOUR METER RESET
M3F:MEMORY CARD UTILITY
SETUP MAINTENANCE MODE
*
M40 : EXTENDED MENU
M49 : RESET ALL SETUP
n
The typeface of charac-
ters displayed on the
video monitor differs
from the actual one.
SERVO
CHECK
CHECK
SERVO
ADJUST
ADJUST
ADJUST
n
The display on the left is
one of the displayed
ON
ON
examples.
ON
09:23:00
2-1
Advertisement
Table of Contents
