V-Belt Installation - Titan 125FLAILSHFT Operator's Manual

V-BELT INSTALLATION

1. Remove belt cover and loose gearbox mounting bracket bolts as well as adjusting bracket
bolts.
2. Loose tension bolt and nut to disengage belt tension until belt can be removed.
3. Replace new belt and turn the tension bolt until desired tension is achieved. Retighten
tension nut and then retighten tension plate bolts, last retighten gearbox mounting bolts.
When the belt has the correct tension, the gearbox should be adjusted so that the
gearbox extension is running straight (parallel) with the flail mower.
4. Reinstall pulley cover.
STORAGE
At the end of the working season or when the mower will not be used for a long period. It is
good practice to clean off any dirt or grease that may have accumulated on the mower and any
of moving parts.
1. Cleaning necessary.
2. Check blades for wear and replace if necessary.
3. Inspect mower for loose, damaged, or worn parts and adjust or replace as needed.
4. Store unit inside, if possible, for longer life.
5. Repaint parts where paint is worn or scratched to prevent rust.
16