Mowing Instructions - Titan 125FLAILSHFT Operator's Manual

Flail side shift mower
Table of Contents

Advertisement

TRANSPORTING
NOTE: Always disengage PTO before raising mower to transport position.
1. When raising the mower to transport position, ensure that the driveline does not contact
the tractor or mower. Adjust and set tractor drawbar height so the driveline does not
reach the mower deck in the fully raised position.
2. Be sure to reduce tractor ground speed when turning, leaving enough clearance so that
the mower does not contact obstacles such as buildings, trees, or fences.
3. Select a safe ground travel speed when transporting from one area to another. When
traveling on roadways, transport in such a way that faster moving vehicles may pass
safely.
4. When traveling over rough or hilly terrain, shift the tractor to a lower gear.

MOWING INSTRUCTIONS

1. Clear area to be mowed of objects and debris that might be picked up and thrown by the
mower blades.
2. Grass is best cut when it is dry. Mowing wet grass can cause plugging resulting in grass
clumps behind the mower.
3. Grass should be mowed frequently as shorter clippings deteriorate faster.
4. If mowing extremely tall grass, it is best to raise cutting height and mow the area, then
lower cutting height and mow a second time at the desired height.
OPERATING INSTRUCTIONS
Before beginning to mow, the user should perform the following inspection:
1. Check oil level in gearbox.
2. Check that all plugs in the gearbox are properly replaced and tightened.
3. Be sure all mower blades, bolts, and nuts are tight.
4. Be certain all guards and shields are in place and secure.
5. Grease driveline shaft and all other grease fittings.
6. Clear area to be mowed of rocks, branches, and other foreign objects.
7. Lower mower to ground. Set tractor throttle at approximately ¼ open. Engage PTO to start
blades rotating.
8. Operate with 540 rpm PTO tractor.
9. At first begin mowing at a slow forward speed and shift up until the desired speed is
achieved maintaining 540 rpm PTO
10. Mower blades will cut better at a faster blade speed than at reduced throttle.
11. After mowing the first 50 feet, stop and check to see that the mower is adjusted correctly.
12. Do not make sharp turns or attempt to back up while the mower is on the ground.
13. Do not engage PTO with the mower in the fully raised position. Do not engage PTO at full
throttle.
14. Do not allow anyone, including yourself, near the mower when it is operating.
15. Periodically check for foreign objects wrapped around the rotor shaft and remove them
after disengaging PTO, turning off the tractor, and removing the ignition key.
13

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

155flailshft185flailshft191527191528191529

Table of Contents