Advertisement
Scan for full manual
Step 1: Check what's in the box
VM-24H 2 Input 1:4 HDMI Distributor
1 Null modem adapter DB9S/DP9P
Kramer RC-IR3 infrared remote control transmitter with batteries and user manual
Step 2: Get to know your VM-24H
#
Feature
1
IR Receiver
2
POWER Switch
3
SELECT IN 1 Button
4
SELECT IN 2 Button
5
EDID READ Button
6
EDID SELECT Button
7
OUTPUT STATUS 1-4 LEDs
8
INPUT 1 HDMI™ Connector
9
INPUT 2 HDMI Connector
10
OUTPUT HDMI Connectors
11
RS-232 9-pin D-sub Port
12
REMOTE IR Opening
13
Power Connector with Fuse
The terms HDMI, HDMI High-Definition Multimedia Interface, and the HDMI Logo are trademarks or registered trademarks of HDMI Licensing Administrator, Inc.
VM-24H Quick Start
VM-24H Quick Start Guide
This guide helps you install and use your
Go to
www.kramerav.com/downloads/VM-24H
upgrades are available.
Function
The red LED is illuminated when receiving signals from the Kramer infrared remote
control transmitter.
Illuminated switch for turning the
Press to select source 1 and distribute this signal to the outputs.
Press to select source 2 and distribute this signal to the outputs.
Press, after pressing the EDID SELECT button, to acquire the EDID (see Step 6).
Press to show the EDID status.
Press to select the EDID mode (One Output, Auto-mix or Default).
Light when an output(s) is connected and active.
Flash to indicate the type of EDID acquired or when connecting a non-HDCP display
while providing HDCP content to the VM-24H.
Connect to the HDMI source 1.
Connect to the HDMI source 2.
Connect to the HDMI acceptor (from 1 to 4).
Connect to the PC or the Remote Controller (see Step 4).
Connects to an external IR receiver unit for controlling the machine via an IR remote
controller instead of using the front panel IR receiver.
Optional. Can be used instead of the front panel (built-in) IR receiver to remotely control
the machine (only if the internal IR connection cable has been installed).
AC connector enabling power supply to the unit.
VM-24H
for the first time.
to download the latest user manual and check if firmware
1 Set of rack ears
1 Power cord
VM-24H
ON or OFF.
P/N: 2 9 0 0 - 3 0 1 2 6 7 QS
4 Rubber feet
1 Quick start guide
Rev: 2
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Kramer VM-24H
Summary of Contents for Kramer VM-24H
- Page 1 Kramer RC-IR3 infrared remote control transmitter with batteries and user manual Step 2: Get to know your VM-24H Feature Function The red LED is illuminated when receiving signals from the Kramer infrared remote IR Receiver control transmitter. POWER Switch Illuminated switch for turning the VM-24H ON or OFF.
- Page 2 Crossed cable – connect only pin 2 to pin 3, pin 3 to pin 2, and pin 5 to pin 5. Note: Typically, hardware flow control is not required for the VM-24H. In the rare case when a controller requires hardware flow control, short pin 1 to 7 and 8, and pin 4 to 6 on the controller side.
Need help?
Do you have a question about the VM-24H and is the answer not in the manual?
Questions and answers