Ford 1996 Thunderbird Manual page 102

NOTE: If your speed increases above your set
speed while driving in D (Drive) on a
downhill grade, you may want to
depress the Transmission Control
Switch located on the shift lever to
turn off overdrive to reduce vehicle
speed. Speed control cannot reduce the
vehicle speed if it goes above your set
speed on a downhill grade.
Do not use the speed control in heavy
traffic or on roads that are winding,
slippery, or unpaved.
Accelerating With the Speed Control
Operating
You can use the accelerator pedal to speed up
momentarily. When you take your foot off the
accelerator, the vehicle will return to the set
speed.
Resetting the Speed Control
To reset the speed control to a lower speed, use
one of the following procedures:
COAST — Press and hold the COAST switch.
Release the switch when the vehicle slows
down to the desired speed.
Lightly tap the brake pedal. When the vehicle
attains the desired speed, press the SET
ACCEL switch and release it immediately.
If vehicle speed is reduced below 30 mph
(50 km/h) by any of the above methods, then
you must manually accelerate to a speed over
30 mph (50 km/h) and reset the system.
RWARNING
99