Recording With Microphone - Example; 4: Erasing A User Message; 5: Voice Loader Software - Honeywell NOTIFIER NFC-50/100 Instruction Manual

Recording Custom Messages

Recording with Microphone - Example

To record into message slot 5 via the microphone:
Enter the Local Recording mode via the online programming utility. Select the Message Record Mode option. The display board will
light green zone 1-14 LEDs for all message slots that are occupied.
If a message already exists in message slot 5, it must first be erased. Press zone button 24, then zone button 5. (See Section 3.5.4) When
the message has been erased, the green zone LED will turn off.
To record the message, press zone button 17, then zone button 5. The yellow zone LED will blink.
Press the PTT button on the microphone and speak the message. Release the PTT button to save the message. The yellow zone 5 LED
will stay lit while recording. The green LED for zone button 5 will light after the recording is complete.
Enter programming mode again and deselect Message Record Mode.
Press zone button 5
to select message
slot 5
3.5.4 Erasing a User Message
Messages stored in message slots 1-14 can be erased.
1. Enter programming mode at the main control board.
2. Enable Recording Mode in the system's message recording programming section. Refer to Section 3.5.1 on page 61. The display
board will then light the green zone 1-14 LEDs for all message slots that contain messages.
3. Press zone button 24 on the display board, then zone button 1-14 for the slot to be erased. The associated green zone LED will stay
lit until complete.
4. Enter programming mode and deselect Message Record Mode.
3.5.5 Voice Loader Software
The Voice Loader (VL) software is used to download recorded messages (in .ske format stored on a computer's hard drive) to the various
message slots of the NFC-50/100. Messages can be uploaded, stored, and used again in similar installations.
Make sure the system is in Normal Standby mode.
To write a message to the panel follow steps 1 through 5. To read a message from the panel follow steps 1 through 4. To move a message
from one message slot location to another, follow the combination of steps.
Notifier FirstCommand Series Manual — P/N LS10001-001NF-E:H 1/8/2018
Figure 3.1 Microphone Recording Example
Programming
Press zone button
17 to record
63