Addressing External Data Bus Devices - Honeywell NOTIFIER NFC-50/100 Instruction Manual

Installation
When installing the NFC-XRM-70V, be sure to:
 carefully remove the factory-installed jumper plug from connector J12 on the main control board.
 set SW5 on the NFC-50/100 main control board to 70V operation.

2.14 Addressing External Data Bus Devices

The table below defines an address map for the external data bus devices which include the NFC-LOC, NFC-RPU, NFC-RM,
NFC-50DA, and NFC-125DA. Dipswitches are used on each of these devices to set the bus address in order to properly communicate
with the NFC-50/100 panel. Any combination of up to eight (8) remote consoles (NFC-LOC, NFC-RPU, and NFC-RM) can be used in
the system. Their external data bus addresses must be unique. Note that these four (4) consoles occupy two (2) data bus addresses each.
The second address is already "reserved" in the system for each console. Up to eight (8) distributed amplifiers (NFC-50DA and
NFC-125DA) can be used in the system. Their external data bus addresses must also be unique and sequential. All addressing must also
be set in user programming. Refer to Section 3.2.3 on page 55.
Bus Address
48
Device
0 reserved
1 reserved
2 reserved for POC
3 reserved
4 LOC or RPU or RM #1
5 reserved
6 LOC or RPU or RM #2
7 reserved
8 LOC or RPU or RM #3
9 reserved
10 LOC or RPU or RM #4
11 reserved
12 LOC or RPU or RM #5
13 reserved
14 LOC or RPU or RM #6
15 reserved
16 LOC or RPU or RM #7
17 reserved
18 LOC or RPU or RM #8
19 reserved
Dipswitch Setting Dipswitch Setting
on LOC (SW1) on RPU (S11)
ON ON
5 4 3 2 1 5 4 3 2 1
n/a n/a
n/a n/a
n/a n/a
n/a n/a
n/a n/a
n/a n/a
n/a n/a
n/a n/a
n/a n/a
n/a n/a
n/a n/a
n/a n/a
Notifier FirstCommand Series Manual — P/N LS10001-001NF-E:H 1/8/2018
Addressing External Data Bus Devices
Dipswitch Setting
on RM (S1)
1 2 3 4 5
ON
n/a
n/a
n/a
n/a
n/a
n/a
n/a
n/a
n/a
n/a
n/a
n/a