Troubleshooting - Encore Rage ER32FS600VL Operator's Manual

IMPORTANT: It is essential that all operator safety mechanisms be connected and in proper operating condition
prior to mower use.
When a problem occurs, do not overlook the simple causes. For example, starting problems could be caused by
an empty fuel tank.
The following table lists some of the common causes of trouble. Do not attempt to service or replace major items
or any items that call for special timing of adjustments procedures. Have this work done by your Service Dealer.
PROBLEM
Engine will not start or is Hard To Start
Stops Suddenly or Lacks Power
Engine Overheats
Mower Pulls Left or Right
Mower Cuts Unevenly
Mower Deck Not Engaging
Mower Vibrates
Mower moves slowly or not at all
Hydraulic Oil Leakage

TROUBLESHOOTING

POSSIBLE CAUSE
No Fuel
Controls are not positioned properly for start
Air Filter or Air Screen is Dirty
Faulty Spark Plug
Improper Fuel
No Fuel or improper Fuel
Engine Overloaded
Dirt in Fuel Line
Air Filter or Air Screen is Dirty
Incorrect Oil Level
Blocked Fuel Filter
Engine Overloaded
Dirty Air Filter or Air Screen
Dirt in Fuel Line
Incorrect Oil Level
Unequal Tire Pressure
Tracking Adjustment Incorrect
Unequal Tire Pressure
Deck leveling Incorrect
Blades Dull or Damaged
Belt is damaged or has slipped
Clutch fuse failure
Blades Dull or Damaged
Engine Bolts are Loose
Drive belt for Hydraulic is loose or has slipped
Linkage loose
Bypass valve on pump is open
Damaged Seals or gaskets
Air in Hydraulics
Axle Reservoir over full
35