Encore Rage ER32FS600VL Operator's Manual page 13

DANGER
Charging or jump starting the battery may
produce explosive gasses. Battery gases
can explode causing serious injury.
• Keep sparks, flames, or cigarettes away
from battery.
• Ventilate when charging or using battery
in an enclosed space.
• Make sure venting path of battery is
always open once battery is filled with
acid
• Always shield eyes and face from
battery.
DANGER
Battery electrolyte contains sulfuric acid,
which is poisonous and can cause severe
burns. Swallowing electrolyte can be fatal
or if it touches skin can cause severe
burns.
• Wear safety glasses to shield eyes, and
rubber gloves to protect skin and
clothing when handling electrolyte.
• Do Not swallow electrolyte.
• In the event of an accident, flush with
water and seek medical attention
immediately.
CAUTION
If the ignition is in the "ON" position there
is potential for sparks and engagement of
components. Sparks could cause an
explosion or moving parts could engage
causing personal injury.
Be sure ignition switch is in the "OFF"
position before charging the battery.
WARNING
Removing standard, original equipment
parts and accessories may alter the
warranty, traction, and safety of the
machine. Unauthorized changes to the
engine, fuel or venting system, may violate
EPA and CARB regulations.
WARNING
Hydraulic fluid escaping under pressure can
penetrate skin and cause injury. Fluid
accidentally injected into the skin must be
surgically removed within a few hours by a
doctor familiar with this form of injury or
gangrene may result.
•
Make sure all hydraulic fluid hoses and lines
are in good condition and all hydraulic
connections and fitting are tight before
applying pressure to hydraulic system.
•
Keep body and hands away from pinhole
leaks or nozzles that high pressure
hydraulic fluid.
•
Use cardboard or paper, not your hands, to
find hydraulic leaks.
•
Safely relieve all pressure in the hydraulic
system by placing the motion control levers
in neutral and shutting off the engine before
performing any work on the hydraulic
system.
13