Chevrolet 2002 S10 Pickup Owner's Manual page 352

Two-Piece Front Turn Signal Lamps
1. Remove the headlamp assembly as shown under
-
"Two Piece Composite Headlamp System" earlier in
this section.
3. Unplug the electrical connector.
6-42
2. Locate the locking tabs
on the assembly.
Squeeze the tabs
together and push that
end of the assembly out
while holding the tabs.
The assembly will
swing out.
4. Turn the harness bulb socket counterclockwise to
remove it. Pull the bulb straight out to remove it
from the socket.
5. Push the new bulb into the socket until it snaps
into place.
6. Put the socket into the lamp assembly and turn it
clockwise until it is tight.
7. To reinstall the assembly, snap the outboard end of
the lamp assembly back into the vehicle. Then swing
the assembly in and snap it into place.
8. Install the two retaining clips.
9. Close the hood.