Nature Power 37800 User Manual page 8

Operating
1. Connect the inverter to power source (see inverter connecting section).
2. Switch the inverter's ON/OFF switch to the ON (I) position.
3. The GREEN LED indicator will light, indicating the inverter is receiving power.
4. Switch the inverter's ON/OFF switch to the OFF (O) position.
5. Make sure the device to be operated is turned OFF.
6. Plug the device into the inverter's AC outlet.
7. Switch the inverter's ON/OFF switch to the ON (I) position.
8. Turn the device on.
9. To disconnect, reverse the above procedure.
Note
If more than one device is to be powered, start one device at a time, to avoid a power
surge and overloading the inverter. The surge load of each device should not exceed
the inverter's Continuous Operation wattage rate.
Load devices should not exceed 150 W when using in the vehicle.
Using the inverter with some rechargeable devices may damage the inverter and/or
device. If you are using the inverter to operate a rechargeable device, monitor the
temperature of the inverter for about10 minutes. If the inverter becomes abnormally
hot, disconnect it from the device immediately; do not use the device with the inverter.
Please use the inverter in ventilate condition and make sure the fan is not blocked.
To save energy, the fan will not work unless the following two situations:
1.Load is exceed 30% of the related power of the inverter.
2.Temperature of the inverter exceed 60ºC.
Page 8 of 12