Download Print this page
B-Tech Better by Design Ventry Series Installation Manual & Parts List

B-Tech Better by Design Ventry Series Installation Manual & Parts List

X-large flat panel wall mount

Advertisement

Quick Links

BTV520
INSTALLATION SAFETY INSTRUCTIONS
CAUTION: This wall mount is intended for use only with the maximum weights indicated. Use with flat
screen heavier than the maximum indicated may result in instability causing possible injury.
Do not attempt to install this product until all instructions and warnings have been read and properly
understood. Please keep these instructions for future reference.
B-Tech International Limited, its distributors and dealers are not liable or responsible for damage or injury caused by improper
installation, improper use or failure to observe these safety instructions. In such cases, all guarantees will expire.
General
B-Tech International Ltd recommends that a professional AV installer or other suitably qualified person install this product.
Great care must always be taken during installation as most AV equipment is of a fragile nature, possibly heavy and easily
damaged if dropped. If you do not fully understand the instructions or are not sure how to install this product safely, then
please consult a professional for advice and/or to install this product for you.
Failure to mount this product correctly may cause serious injury or death both during installation and at any time thereafter. Do
not mount any AV equipment that exceeds the specific weight limit of the product you are installing.
This weight limit will be clearly stated on each product and its packaging and will vary from product to product.
Product location
Please pay careful attention to where this product is located. Some walls are not suitable for installation.
If located in a public or frequently populated area ensure that the product is out of the immediate reach of people. If any AV
equipment is to be suspended over the likely path or location of people then great care should be taken to secure all parts of
the installation from falling. If you install this product on drywall it must be securely fixed to a wooden stud, concrete block or
other permanent structure behind the drywall board. Installing on drywall boards alone will not support the weight of most AV
equipment. When drilling holes in walls it is essential to avoid contact with electrical cables and water or gas pipes contained
within. Use of a good quality live wire detector and hidden object locator is therefore recommended. Only drill into structures
when you are sure it is safe to do so.
Fixing hardware
It is highly recommended that all wall fixing screws be used where supplied and that the purpose of all other fixing hardware is
fully understood. In some cases more AV equipment fixing hardware will be supplied to accommodate different models of
equipment and set up configurations. The installer must be satisfied that any supplied fixing hardware is suitable for each
specific installation. If any fixing screws or included hardware are deemed not sufficient for a safe installation then please
consult a professional or your local hardware store.
Hazard limitation
When routing cables take advantage of any built in cable management features that the product might provide and ensure that
all cables are tidy and secure. Check to see that any moving aspect of the product can do so unhindered by any cabling.
Some products have moving parts and the potential to cause injury through the crushing or trapping of fingers or other body
parts.
Particular attention to the nature of moving parts is required especially when assembling installing and adjusting during set up.
Immediately after installations double-check that the work done is safe and secure. Double-check all necessary fixings are
present and are of ample tightness.
It is recommended that periodic inspections of the product and its fixing points are made as frequently as possible to ensure
that safety is maintained. If in doubt consult a professional AV installer or other suitably qualified person.
CS
Společnost B-Tech International Ltd. doporučuje provést instalaci tohoto produktu prostřednictvím odborného instalátora AV či
jinak způsobilé osoby. Společnost B-Tech International Ltd, její distributoři a prodejci nenesou odpovědnost za škody nebo
zranění způsobená nevhodnou instalací. Tento výrobek je nutno umístit do vhodné konstrukce a používat jen po uvedenou
maximální výšku.
DE
B-Tech International Ltd. empfiehlt, dass dieses Produkt durch einen qualifizierten AV-Techniker oder eine andere Person mit
geeigneter Qualifikation installiert wird. B-Tech International Ltd, ihre Distributoren und Händler können nicht für durch
fehlerhafte Montage verursachte Beschädigung oder Verletzung haftbar bzw. verantwortlich gemacht werden. Dieses Produkt
muss auf eine geeignetem Untergrund montiert werden und darf nur bis zum angegebenen Höchstgewicht verwendet werden.
ES
B-Tech International Ltd. recomienda que un instalador de audio y video profesional u otra persona debidamente cualificada
instalen este producto. B-Tech International Ltd, sus distribuidores y concesionarios no se hacen cargo ni se responsabilizan
de ningún daño o lesión provocados por una instalación inapropiada. Este producto se debe montar en una estructura
adecuada y se debe utilizar soportando solamente hasta el peso máximo indicado.
FR
B-Tech International Ltd. recommande de confier l'installation de ce produit à un installateur AV professionnel ou à une autre
personne dûment qualifiée. B-Tech International Ltd, ses distributeurs et ses revendeurs ne sauraient être tenus responsables
de tout dégât ou de toute blessure résultant d'une installation incorrecte. Ce produit doit être monté sur un support approprié
et utilisé dans la limite du poids maximum indiqué.
IT
B-Tech International Ltd. consiglia di affidare l'installazione di questo prodotto a un installatore specializzato o ad altra
persona adeguatamente qualificata. B-Tech International Ltd, i suoi distributori e rivenditori non accettano alcuna
responsabilità nei riguardi di eventuali danni o infortuni causati da un'errata installazione. Questo prodotto deve essere fissato
a una struttura idonea e utilizzato unicamente sino al peso massimo indicato.
NL
B-Tech International Ltd. adviseert om dit product te laten installeren door een professionele AV-installateur of andere
hiervoor gekwalificeerde persoon. B-Tech International Ltd, haar distributeurs en dealers zijn niet aansprakelijk of
verantwoordelijk voor schade of letsel die is veroorzaakt door onoordeelkundige installatie. Dit product moet worden
gemonteerd aan een geschikte constructie, waarbij het aangegeven maximum gewicht niet mag worden overschreden.
PL
Firma B-Tech International Ltd. zaleca, aby ten produkt był instalowany przez profesjonalnych instalatorów AV lub inny
odpowiednio przeszkolony personel. Firma B-Tech International Ltd, jej dystrybutorzy i dealerzy nie ponoszą
odpowiedzialności za uszkodzenia lub obrażenia ciała powstałe w wyniku nieprawidłowej instalacji. Niniejszy produkt musi być
zamontowany na odpowiedniej powierzchni, a podczas użytkowania nie wolno przekraczać podanego maksymalnego
obciążenia.
PT
A B-Tech International Ltd. recomenda que a instalação deste produto seja efectuada por um instalador de AV profissional ou
outra pessoa devidamente habilitada. A B-Tech International Ltd. e os seus distribuidores e concessionários não são
responsáveis por danos ou lesões causados por uma instalação incorrecta. Este produto tem de ser montado numa estrutura
adequada e utilizado somente até ao peso máximo indicado.
RU
Компания B-Tech International Ltd. рекомендует, чтобы установка данного изделия производилась инженером по
установке аудио-видеотехники или другим специалистом с соответствующей квалификацией. Компания B-Tech
International Ltd., ее дистрибьюторы и дилеры не несут ответственности за повреждения или травмы, полученные в
результате неправильной установки. Данное изделие должно крепиться к соответствующей конструкции и
использоваться для поддержания оборудования, вес которого не превышает указанный максимальный вес.
©2010 Bennett Technologies Limited. All rights reserved. B-Tech Audio Video Mounts is a division of Bennett Technologies Limited. B-Tech, Better By Design & Ventry are registered trademarks of Bennett Technologies Limited. All other brands and
X-LARGE FLAT PANEL WALL MOUNT
INSTALLATION GUIDE & PARTS LIST
This Pack Contains 1 Mount
PLEASE KEEP THIS PARTS LIST FOR FUTURE REFERENCE
product names are trademarks of their respective owners. Photographs are for illustrative purposes only. E&OE.
Suitable for VESA and non-VESA screens
up to 63"
Mounts screen only 20mm from the wall
Suitable for concrete, brick or stud walls
up to 32"
Post-installation screen alignment
Simple hook-on installation with all mounting
hardware included
TOOLS REQUIRED
13mm (1/2") spanner
Crosshead
or socket
screwdriver
10mm (7/16")
masonry bit or
6mm (1/4") wood bit
B-TECH AUDIO VIDEO MOUNTS
Bennett House, Long March, Daventry, Northants NN11 4NR, UK
Email: info@btechavmounts.co.uk
EUROPE
NORTH AMERICA
Brixtonlaan 32, Zaventem 1930,
203 Eggert Road,
Brussels, Belgium
Buffalo, NY 14215, USA
Email: info@btechproav.com
Email: info@btechavmounts.com
IP-BTV520-V1.1-VT1BX-240210-09 MADE IN CHINA
Drill
Pencil
Level
Stud finder
(optional)
(optional)
HEAD OFFICE
ASIA PACIFIC
Ruby Industrial Complex,
1503 Prosperity Millennia Plaza,
Singapore 347740
Quarry Bay, Hong Kong
Email: info@btechavmounts.com.sg
Email: info@btechavmounts.com.hk
CHINA

Advertisement

loading

Summary of Contents for B-Tech Better by Design Ventry Series

  • Page 1 IP-BTV520-V1.1-VT1BX-240210-09 MADE IN CHINA ©2010 Bennett Technologies Limited. All rights reserved. B-Tech Audio Video Mounts is a division of Bennett Technologies Limited. B-Tech, Better By Design & Ventry are registered trademarks of Bennett Technologies Limited. All other brands and product names are trademarks of their respective owners. Photographs are for illustrative purposes only. E&OE.
  • Page 2 BTV520 INSTALLATION INSTRUCTIONS 1. Attach wall plate to either a concrete or stud wall. i. Concrete wall ii. Stud wall...
  • Page 3 2. Attach interface arms to flat screen. MULTIWASHER PART M FLAT SCREEN G/H/I 4. Hook mount onto wall plate. 5. Lateral adjustment. WALL FLAT SCREEN FLAT SCREEN...
  • Page 4 BTV520 PARTS LIST PLEASE KEEP THIS PARTS LIST FOR FUTURE REFERENCE PART NAME INTERFACE KIT WALL PLATE M4 X 12mm SCREW INTERFACE ARM M4 X 25mm SCREW M5 X 16mm SCREW FIXING KIT M5 X 25mm SCREW M8 X 50mm COACH SCREW M6 X 16mm SCREW M8 METAL WASHER M6 X 25mm SCREW...

This manual is also suitable for:

Btv520