Table of Contents
Advertisement
Warning
•
For maintenance use only specified replacement parts.
•
To avoid electrical shock, do not attempt to perform any servicing
unless you are qualified to do so.
•
Do not perform any service while the FlexProbe
circuit.
•
To avoid electrical shock and/or damage to the instrument, do
not get water or other foreign agents into the electronic module.
•
Also see warning on page 1.
5.1
Changing the Battery
If the power ON indicator (green LED) blinks or does not light up, replace
the battery.
Disconnect the instrument from any source of electricity.
•
To replace the battery, open rear case, replace battery and
re-assemble.
•
The green LED should go on when the module is turned on.
5.2
Cleaning
•
Use a soft cloth lightly dampened with soapy water, then dry with
a dry cloth.
•
Do not splash water directly on the instrument.
•
Do not use alcohol, solvents or hydrocarbons.
•
Make sure the sensor, electronic module, and all leads are dry
before any further use.
12
CHAPTER 5
MAINTENANCE
is on any
®
FlexProbe
- Flexible AC Current Probe
®
Advertisement
Table of Contents
