Heatshift™ System-If Used; Remove Convection Baffle; Install Heatshift Take-Off Collars To Appliance - Valor 1500KN Installation Manual

Installation
ONLY If You Are Installing HeatShift!
Perform the following steps and see "Appendix D—
HeatShift System" on page 73 for more details
regarding HeatShift planning and installation.
Remove Convection Baffl e
To be eff ective, the HeatShift system requires that an
internal convection baffl e located above the fi rebox
inside the appliance case be removed to allow the hot
air fl ow to convect upwards into ducts installed on the
fi replace.
Remove the convection baffl e from the appliance. It is
held in place by 3 screws located right behind the upper
edge of the fi replace opening. Recycle this panel as it is
no longer needed.
Appliance front panel—shown transparent for clarity
C o
n v e
c t i o
n b
a ffl
e
Remove convection baffl e
WARNING
The Linear fireplaces requires the
removal of the internal convection baffle
for the HeatShift system to function
properly—read instructions carefully!
34
HeatShift™ System—if used
Install HeatShift Take-Off Collars to Appliance
1. Remove the four cover plates on top of the appli-
ance case (6 screws each).
2. Install the collars on the holes on top of the appli-
ance's case (6 screws each).
WARNING
A l l F O U R ( 4 ) t a k e o f f s M U S T B E
C O N N E C T E D T O P L E N U M ( S ) .