Overview - Valor 1500KN Installation Manual

Installation Planning
Remote
Handset
Wall Holder
S S urrou nd d d Plate Pl l with i i
Bar r rier Screen (required)
Narr r ow 1" Trim 1575LFB and
wide e r 3-1/2" steel Trim 1550
adjus s table, accept additional
non-combustible fi nish over
cement board and
behind trim. 1530CIK's
narrow trim requires
HeatShift.
Cement board finishes up to
perimeter of trim.
Note: 1530CIK installs before
cem ce cem cem e t ent ent ent board bo bo bo ard ard a d.
Wall l l l l Fi i i i ini sh
A A ny wall fi nishes applied
o o ver cement board must
be non-combustible.
Com m bustible mantel are ok
provided they conform to
chart on page 11.
Combustible Floor
WARNING
Some materials or items, although safe,
may discolor, shrink, warp, crack, peel,
and so on because of the heat produced
by the fireplace. Avoid placing candles,
paintings, photos, and other items
sensitive to heat around the fireplace.
10
h h
. . .
h h
Hearth: not required.
If used, must be minimum 4" below
fi replace opening unless using LDK
HeatShift Duct Kit (see installation
instructions packed with kits).
Note: This appliance may be installed in outdoor, weather
protected environments as defi ned in the GV60CKO Outdoor
Conversion Kit instruction manual.
Mantel—See Mantel & Hearth Clearances
Framing—See Framing Requirements
1/2 inch thick non-combustible cement board –NOT supplied
Supplied as vertical outlet, fi eld convertible to horizontal
outlet. Note - Vertical rise required in vent system
Optional LDK HeatShift
Duct Kit outlets (4)
Combustible Framing Allowed Beneath Fireplace. When the appliance
is installed directly on carpeting, tile or other combustible material
other than wood fl ooring, the appliance shall be installed on a metal
or wood panel extending the full width and recessed depth of the
appliance.
WARNING
HOT WALL SURFACES! The wall directly
above the fireplace is constructed of non-
combustible materials and, although safe,
it may reach temperatures in excess of
200°F (93°C) depending on choice of trims.
Do not touch. Finish wall using materials
suitable for these temperatures.

Overview

Remote Battery
and Wall Switch Kit
(required) (35-foot wire
length) (supplied)
1500K heater
Electrical
junction box
(not supplied) to
connect power
when using
optional fan, WiFi