Konica Minolta FS-107 Service Handbook page 24

FS-107
*2 Paper exit
In the straight mode, paper conveyed to the paper
exit gate by the conveyance rollers is conveyed to
the tray through paper pressure being applied to
paper exit roller/A by the paper pressure motor
(M707) and the roller being made to run forward.
(Does not apply to small paper sizes.)
In offset mode or staple mode, when the stacked
paper is conveyed, paper pressure being applied
to paper exit roller/A by the paper pressure motor
(M707) and the roller being made to run forward,
all the stacked paper is conveyed into the tray.
1
Straight mode
Offset mode/staple mode
REVISED EDITION
1
Paper exit roller/A
DATE
May 2000
*3 Paper stack
In the offset mode or staple mode, paper con-
veyed to the paper exit gate by the conveyance
rollers is then conveyed to the stack position by
paper exit roller/A running in reverse direction.
The conveyed paper is sent to the stopper by the
friction of the conveyance belt and stacked.
*4 Stapler unit shift
The stapler unit is driven by the stapler shift motor;
1
the stapler unit is fixed on the staple base and
moved by a belt along a rail. Owing to the shape of
the rail, when the stapler unit is moved to either the
forward or rear positions, the unit rotates and it is
possible to staple slantwise.When the stapler is
set to staple in two locations, it moves to the first
location, puts in the first staple, then moves to the
second location to put in the second staple.
Stapler unit
Rails
Belt
PAGE
2-8
2-8
Stapler shift motor
(M705)
METHOD
REPLACEMENT