Removing And Installing The Stapler Unit - Konica Minolta FS-107 Service Handbook

FS-107
[6] Removing and reinstalling the
1
stapler unit
(1) Remove the finisher from the main unit.
(2) Take out the fixing plates of the plate affixing the
stapler unit, from the rear of the finisher unit.
(3) Slide the plate and remove.
Hook
Caution: When reinstalling the plate, be sure to
insert the plate into the insides of the
hooks.
(4) Take out the connector and 1 grounding screw
from the stapler unit.
Ground
Grounding screw
REVISED EDITION
1
Set screw
Plate
Connector
DATE
3-6
May 2000
(5) Take out the set screw from the unit saddle, slide
out and remove the stapler unit.
Stapler units
(6) Install by reversing the removal procedure.
PAGE
3-6
Set screw
METHOD
REPLACEMENT