16-8
GHL88H Circuit Board
Remove the black and white key assemblies (C5-C7).
(See procedure 16-1.)
Remove the five (5) screws marked [260C]. The
GHL88H circuit board can then be removed. (Fig.13)
<Top view> <上から見た図 >
Keyboard assembly
(GHL鍵盤Ass'y)
Hammer (White Key), (Black Key)
16-9
Remove the black and white key assemblies for the
related keys.
With the key frame placed upside down, push the
hammer forward from the rear, then a click sound is
heard and the hammer bearing section can be removed
from the hammer axis of the key frame.
Take out the hammer sideways. (Fig.16, Fig.17)
*
When removing the hammer, take care not to cause
damage to the hammer bearing and its claw.
<Rear view> <後ろから見た図 >
Hammer axis
(ハンマー軸)
Bottom side
(ボトム側)
Frame
Hammer, black key
(鍵盤フレーム)
(ハンマー(黒鍵))
Fig.16(図 16)
Filament tape
(フィラメントテープ)
CN2 (27P)
GHL88M
Bearing claw
(軸受け爪)
Hammer, white key
(ハンマー(白鍵))
Push
(押す)
16-8
GHL88Hシー ト
C5〜C7までの白鍵Ass'y、 黒鍵Ass'yを外し ます。
(16-1項参照)
[260C]のネジ5本を外して、 GHL88Hシー ト を外します。
(図13)
FFC cable
(FFCケーブル)
(FFCケーブル)
Through hole
(通し穴)
Fig.15(図 15)
16-9
ハンマー (白鍵) 、 (黒鍵)
該当する白鍵Ass'y、 黒鍵Ass'yを外します。
鍵盤フ レーム を裏側に して、 後方からハンマーを前に押す
と、 「カチ ッ」と音がして鍵盤フ レームのハンマー軸からハン
マーの軸受け部が外れます。
ハンマーを横に して取り 出し ます。 ( Fig.16, Fig.17)
※
ハンマーを外すとき、ハンマーの軸受け爪や軸受け
部を傷めないように注意して作業してください。
DGX-630/YPG-635
<Side view> <横から見た図 >
FFC cable
Filament tape
(フィラメントテープ)
Frame
(フレーム)
CN2
GHL88M
(27P)
Hammer, B1 (black key)
(ハンマーB1(黒鍵))
Hammer, W1 (white key)
(ハンマーW1(白鍵))
Bearing claw
(軸受け爪)
Bearing section
(軸受け部)
Fig.17(図 17)
19