Summary of Contents for Flight Model Extra 330SC 100CC
Page 1
Wing Span:106in/2693mm; Flying Weight:11700g; Wing Area:138sq.dm; Radio:6Channel 11Servos; Length:94.5in/2400mm; Engine:100CC Gas CAUTION : this plane is not a toy and should be kept away children under 16 years of age! Before use , please carefully read this manual. ●First-time builders should seek advice from people having building experience in order to assemble the model correctly and to produce its performance to full extent .
Page 2
Main Wings All the wing parts together Cut the servo holes on the bottom of the main wings Install the servo and fix it with screws.
Page 3
Use 3*12 screws to lock the servo-tray to the Wing Cut the film covering as shown Insert the fiberglass control horn , and glue with AB glue...
Page 4
Connect the servo arms and aileron control horn by pushrod with ball links. Finished photo Install Wingtip & Winglet...
Page 5
Finished photo Connect the main wings and the fuselage with Carbon fiber tube. Main Landing Gear and Tail Wheel Unit Gather the parts for the main landing gear.
Page 6
Tail Wheel parts Slide cuffs into position on the landing gear.perform a quick fit check on the fuselage to verify cuffs are properly oriented Use screw to connect the landing gear, wheel pant, nut and wheel in turn, and finally use a lock nut to lock them.
Page 7
Insert the wheels and axles into main landing gear with the nylock nuts. Install the wheel cover,and fix it up to landing gear with screw. Fix up the landing gear on the fuselage bottom with 4 screws.
Page 8
Drill a hole at the Original design hole of the cuffs Use screws to lock the cuffer and landing gear Rudder Put the steel wire in the hinges between the rudder and the connecter of vertail fin...
Page 9
Put the tail wheel set into the hole, and use two pcs self-tapping to lock the tail wheel onto the fuselage tail. Cut the film and let the steel wire outside. Cut out the hinges film...
Page 10
Using a knife,remove covering the film above the gear plates Insert the fiberglass control horn sheet and gear plates. Use AB glue to glue it. Connect the rudder to the fuselage the horns into the original design hole...
Page 11
Install the rudder servo,as shown Put the servo into fuselage Use screws to fix up the servo on the fuselage...
Page 12
Attach the servo arm to the ruddert servo as shown Cut out the holes on the stabilizer Finished photo.
Page 13
Cut the gear plates film on the elevator Connect the servo arm and elevator servo with ball links and pushrod Connect the stabilizer and the fuselage with joiner...
Page 14
Use 3*15 screws to fix up the fuselage Cowl Fasten the fuel tank onto the fuselage as shown. Install the Engine as shown Start by installing the lower cowling half...
Page 15
Slide the top cowling half into position,use screw to fix it .as pictured above Install the propeller and spinner.
Page 16
Assemble Canopy as photo shown CG POSITION & CONTROL THROWS...
Need help?
Do you have a question about the Extra 330SC 100CC and is the answer not in the manual?
Questions and answers