Battery Installation And Solenoid Wiring; Prg; Battery Power - Hunter XC Hybrid Quick Start Manual

Battery Installation and Solenoid Wiring

BATTERY POWER

The XC Hybrid plastic model operates with six AA alkaline batteries,
and the XC Hybrid stainless steel model uses six alkaline C
batteries. A battery carrier is supplied with the controller. Insert the
batteries as indicated on the battery carrier.
• To install the battery on the XC Hybrid plastic model, connect
the battery connector inside the access compartment to the
battery carrier. Then insert the carrier into the lower left side of
the controller as shown.
• To access the battery carrier on the XC Hybrid stainless steel
model, remove the screw in the top center of the controller and
tilt the facepack down as shown.
• The XC Hybrid stainless steel solar model comes out of the box
ready to install and program. Place the controller in full sunlight.
Turn the dial to the RUN position to activate solar charging.
XC HYBRID WIRE SIZING CHART
Wire Size
18 AWG (0.8 mm )
2
16 AWG (1.3 mm )
2
14 AWG (2.1 mm )
2
12 AWG (3.3 mm )
2
4
Distance from Valve to Controller
550' (168 m)
870' (265 m)
1,380' (421 m)
2,200' (671 m)

PRG

SENSOR BYPASS
ACTIVE
Plastic model
Stainless steel
model
Stainless steel solar
model
https://hunter.help/XCHybrid