Solenoid Connections - Electric Vih Models - Hunter G835 Owner's Manual

Solenoid ConneCTionS – eleCTRiC ViH ModelS
tts electric Valve-In-Head models have solenoid lead wires protruding from the rotor's body in the traditional
manner. controller field wires can be connected to the rotor, using the specified watertight wiring connectors, at this
sub-surface position. If specified or requested otherwise, the solenoid lead wires and controller field wires can be
pulled up into the rotor's flange compartment where the initial connections can be made (recommended). Regardless
of the initial connection point, future solenoid repair connections can be made within the flange compartment. (see
solenoid servicing later in this manual)
recoMMended WIrIng connectIons
Recommended Wiring
Connections
Caution! When connecting solenoid leads outside of the flange compartment, DO NOT pull solenoid leads
downward in an attempt to provide more exposed solenoid wire. electric tts rotors reQuIre slack in solenoid wiring
within the flange compartment to facilitate servicing of the pilot valve and solenoid. Removing the slack can limit
movement of the on-auto-off selector and require cutting of solenoid wires to service pilot valve and/or solenoid.
do not pull on
solenoId lead WIrIng
4