Test Program; System Off; Programmable Rain Off; Sensor Bypass - Hunter XC Hybrid Quick Start Manual

TEST PROGRAM

Runs all stations for a test run time.
1. Press and hold PRG for three seconds.
2. Station 1 appears. Press + or – to enter run time.
3. Wait two seconds; each station will run for test run time.

SYSTEM OFF

Turn dial to system OFF position. No watering will occur in
this dial position.

PROGRAMMABLE RAIN OFF

1. Turn dial to system OFF position and wait for OFF to
stop blinking.
2. Press + or – to set the number of days to remain off.
3. Turn dial back to RUN position. Display will show days off
remaining, and watering will resume when Off days reach
0. To cancel Rain Off, turn dial to OFF, wait until OFF stops
blinking, then turn dial back to RUN.
Built on Innovation
®

SENSOR BYPASS

Overrides sensor shutdown to allow watering.
1. Move sensor BYPASS switch to BYPASS position.
2. Return switch to ACTIVE to allow sensor shutdown.
SCHEDULING TIPS
• A program is a watering schedule that includes Start
Time(s), Run Time(s), and Water Day(s).
• A Start Time is the time of day the Stations in the
Program start watering.
• A Run Time is the watering length per Station (zone).
• One Start Time is needed to run the entire program.

FULL RESET

1. Press and hold down the –, ►, and PRG buttons simultaneously.
2. Press and release the RESET button on the right side of
the controller.
3. When DONE appears on the LCD, release the –, ► and
PRG buttons. The display should now show 12:00 AM.
The memory has now been cleared and the controller may
be reprogrammed.
NOTE: The reset button is located inside the wiring compartment.
Setup
7