Installation Details - Hunter TTS-800 Series Owner's Manual

Wiring Diagram
The diagram below illustrates wiring connections for two-way module systems.
B
A
The diagram below illustrates wiring connections for conventional systems.
B
A
|
Visit support.hunterindustries.com
C
C

Installation Details

Installation Best Practices
A. Adjust the swing joint to level the top
surface of the rotor body with the finished
grade. Backfill the area around the body
with sand for proper drainage and tamp
down the soil to prevent settling.
B. Solenoid and two-way module
connections are designed to be made
inside the flange compartment using
DBRY-6 waterproof connectors.
C. Leave enough slack in the wire to make
any needed future adjustments.
D. All models have 1½" (40 mm) Acme
threaded inlets. Do not use NPT or BSP
threaded fittings to connect TTS-800
rotors. Adapters are available to attach
NPT or BSP swing joints to Acme threads.
E. Rotate the TTS-800 rotor body clockwise
to tighten by hand until it bottoms out.
Then unwind a half-turn to allow for
minor adjustment after installation. Acme
threaded inlets come with an O-ring to
create a seal. Do not use Teflon® tape,
PVC cement, or other thread sealant
to connect as these products can
deteriorate the fitting and cause leaks.
5
Page