If Using The High Torque Adapters And The Mounting Plates For High Torque Adapters (Optional) - NBK EPU-220 Instruction Manual

4
Installation and Connections
4.2.5 If Using the High Torque Adapters and the Mounting Plates
for High Torque Adapters (Optional)
The mounting plates for high torque adapters can be used when replacing digital position indicators
with a size of 22 mm (0.866 in.) as shown in Fig. 1 or 30 mm (1.181 in.) as shown in Fig. 2.
Corresponding Positions of Positioning Pin
Size Digital position indicators
22 mm
(0.866
in.)
30 mm
(1.181
in.)
Position of positioning pin
Fig. 1
Fig. 2
27
Mounting plates for high torque adapters
Turn the positioning pin to the left and
remove by using a flathead screwdriver or
similar, and change the position.
(Recommended tightening torque: 0.5 N m
(4.42 lbf in.))
This is the position when shipped from the
factory. Check that the positioning pin is
tightened before use.
(Unit: mm (in.))
Positioning pin
Positioning pin