2
Overview
2.3
Button Operation and Mode Transitions
Operate the buttons on the front of the unit to rotate the output shaft and change modes.
Wait approximately 10 sec.
(no operations) or press the
button
Normal Mode
This is the standby status of
setup execution.
Lights up in green
* For more details regarding the unit registration, please refer to the Dedicated Software (EPU-COM) Instruction Manual.
Press the button
Lights up in green → white
Press and hold the
button for 3 sec. or more
Green → White → Yellow
↔ Blue (flashes alternately)
After unit registration is
completed or press the
button
Press and hold the
and buttons at the
same time for 3 sec. or
more
Green → Light blue
↔ Purple (flashes alternately)
Wait approximately
10 sec. (no operations)
after completing settings or
press the button
Manual Operations Mode
Flashes in white
Press and
hold
Press and
hold
Flashes in white
Unit Registration Selection Mode
Select either wireless or wired unit registration.
Wireless Unit
Press
Registration Mode
Wired Unit
Press
Registration Mode
Terminating Resistor Setting Mode
Switches the terminating resistor setting on/off.
Factory default settings are -A (loose wires type) is set to
"OFF" and -B (connector type) is set to "ON".
Terminating
resistor setting
"ON"
Press
Press
Terminating
resistor setting
"OFF"
12
Output shaft rotates
in the CW direction
Output shaft rotates in
the CCW direction
Lights up in blue
Lights up in yellow
Flashes in purple →
Green (Normal mode)
Flashes in light blue →
Green (Normal mode)