Table of Contents
Advertisement
4
Installation and Connections
4.2.2 If Using the Mounting Plates (Optional)
The mounting plates can be used when replacing digital position indicators with a size of 22 mm
(0.866 in.) as shown in Fig. 1 or 30 mm (1.181 in.) as shown in Fig. 2.
Corresponding Positions of Positioning Pin
Digital position indicators
Size
22 mm
(0.866 in.)
30 mm
(1. 1 81 in.)
Position of positioning pin
Fig. 1
Fig. 2
19
Mounting plates
Turn the positioning pin to the left and
remove by using a flathead screwdriver or
similar, and change the position.
(Recommended tightening torque: 0.3 N m
(2.65 lbf in.))
This is the position when shipped from the
factory. Check that the positioning pin is
tightened before use.
(Unit: mm (in.))
Positioning pin
Positioning pin
Advertisement
Table of Contents
