Game Winner Climber 2.0 Instruction Manual page 20

Installation Instructions
Step 1:
Double check to assure you are
wearing and properly attached to tree
with full body harness. If you are not,
STOP and do not leave the ground.
Step 2:
Raise seating platform up about 4 feet
above standing platform and step onto
platform. Lower seating platform so it
is waist high. Attach harness tree
strap to tree as shown in Figure 14.
WARNING! ALWAYS FOLLOW
INCLUDED SAFETY HARNESS
INSTRUCTION.
Step 3:
While facing the tree, slide seat close to
the tree.
Insert your feet into the looped foot
stirrups on the platform and pull bungee
strap up around back of your ankles.
See Figure 15.
IMPORTANT NOTE: You may need to
adjust foot stirrups loop size by
adjusting webbing through buckles.
Step 4:
With safety harness properly adjusted,
sit on climbing bar and tip standing
platform section forward and lift up
standing platform section by lifting
your legs approximately 8-12 inches.
Level standing platform section by
rotating legs so standing platform
teeth dig into tree. See Figure 16.
WARNING! NEVER JUMP OR
BOUNCE TO SEAT/DIG
TREESTAND INTO TREE.
ASCENDING (CLIMBING UP) THE TREE
Read and understand included Full Body
Harness instructions, warnings, and watch
safety video for instructions on using your
Full Body Harness with tree strap.
Always remain connected to tree with tree
strap from moment you leave ground until
you return to ground.
Figure 14
Figure 15
Figure 16
20