Game Winner Climber 2.0 Instruction Manual page 16

Installation Instructions
Always make sure connector strap is connected to seating and standing
platform of climbing treestand before using. If they are not connected with
connector strap, do not use climbing treestand. Connector strap length is preset
and no adjustment is needed.
Follow all warnings and expiration dates listed on tree strap warning label and in
maintenance section for cables.
WARNING!
Prior to every use, inspect cables and all hardware for damage, including
corrosion. DO NOT USE THIS PRODUCT IF ANY DAMAGE IS SUSPECTED,
including but not limited to cuts, frayed portions, corrosion, bends, or other
damage to treestand, straps, or cables. If such damage is visible or suspected,
DO NOT USE THE PRODUCT.
Failure to follow these instructions can result in serious injury or death.
SETTING UP THE GAME WINNER CLIMBER ONTO THE TREE
Step 1:
Place the Standing Platform
approximately 12 inches off the
ground on the base of tree. Wrap the
Cable Assembly around the back of
the tree trunk and slip into the Cable
Support Arm and insert the Cable
Locking Pin refer to Step 3 through 5
on Pages 12 and 13. Repeat this
step to attach Seating Platform to
tree above Standing Platform as
shown in Figure 8.
WARNING!
The Cable Locking Pin MUST be
positioned with the spring clip on
the outside of the Cable Support
Arm. Prior to using your climber
stand, ensure that the Cable
Locking Pins have indeed
engaged the Cable Assemblies for
both of Seating & Standing
Platform. Failure to follow these
instructions may result serious
injury or death!
Figure 8
Place Standing & Seating
Platform to the tree
16