Game Winner Climber 2.0 Instruction Manual page 12

Assembly Instructions
Step 2:
Locate the Cable Support Arms of
Seating Platform. Rotate the Cable
Support Arms up into an erect
position and secure using two (2)
M8x60 Bolts, four (4) Nylon Washers
and two (2) Locknuts (preassembled
on support bar) as shown in Figure 2.
WARNING!
DO NOT overtighten the hardware.
Overtightening can lead to structural
damage and may negatively affect
the performance of your stand.
Failure to follow these instructions
may result in serious injury or death!
Step 3:
Locate the Cable Assembly pre-
installed on standing platform. You
will notice that there are two molded
ends on the cables. Insert one of
these molded ends into the receiver
on the Cable Support Arms as shown
in Figure 3.
One end of cable must be secured
onto the cable support arm (Step 5)
before mounting / positioning
climber to the tree trunk.
The other one end of cable must
be secured onto the cable support
arm when mounting/positioning
climber to the tree trunk.
Figure 2
Install Cable Support Arms
Figure 3
Insert End of Cable Into Support Arm
12