Related Manuals for Electrolux EWS 1021
Summary of Contents for Electrolux EWS 1021
- Page 1 W A S H I N G M AC H I N E P R A L K A AU TO M AT Y C Z N A AU TO M AT I C K Á P R A C K A AU TO M AT I C K Á...
-
Page 2: Table Of Contents
Transport damages Dear customer, When unpacking the appliance, check that it is not Please read these operating instructions carefully damaged. If in doubt, do not use it and contact the and pay particular attention to the safety notes Service Centre. indicated in the first pages. -
Page 3: Warnings
Warnings The following warnings are provided in the interests of overall safety. You must read them carefully before installing or using the appliance. Installation • Use only the recommended quantities of fabric softener. An excessive amount could damage the • All internal packing must be removed before using laundry. -
Page 4: Disposal
Cotton 4,5 kg Synthetics 1.5 kg Delicates 1.5 kg Woollens SPIN SPEED 1000 rpm max. (EWS 1021) 1200 rpm max. (EWS 1221) POWER SUPPLY VOLTAGE/FREQUENCY 220-230 V/50 Hz TOTAL POWER ABSORBED 2200 W MINIMUM FUSE PROTECTION 10 A WATER PRESSURE... -
Page 5: Installation
Installation Unpacking 7. Plug all the holes with the plugs which you will find in the envelope containing the instruction booklet. All transit bolts and packing must be removed before using the appliance. You are advised to keep all transit devices so that they can be refitted if the machine ever has to be transported again. -
Page 6: Water Drainage
The other end of the inlet hose which connects to the The drain hose must not be kinked. machine can be turned in any direction. Simply loosen the fitting, rotate the hose and retighten the fitting, making sure there are no water leaks For a correct functioning of the machine the drain hose must remain hooked on the proper support piece situated on the top part of the back... -
Page 7: Your New Washing Machine
Your new washing machine This new machine meets all modern requirements for effective treatment of laundry with low water, energy and detergent consumption. • The automatic cooling of the washing water from 95° to 60°C before draining will prevent old drain pipes from being deformed. -
Page 8: Use
(no spin). The light corresponding to the selected option illuminates. Maximum speeds are : • Cottons, linens: 1000 r.p .m. (EWS 1021) 1200 r.p.m. (EWS 1221) • Synthetics, wool and handwash: 900 r.p.m. • Delicates: 700 r.p.m. The selector dial can be turned either clockwise or anticlockwise. -
Page 9: Quick Wash Button
B = Drain 7 Quick wash button To drain the water select B (Drain) programme by This option can be used for lightly soiled items (not for means of the selector dial, then press the wool, handwash, E 60°- E 40°- AA 40° - 60° and START/PAUSE button. - Page 10 Cancelling Incorrect option selection If a programme has been cancelled – programme If an option which is not compatible with the set wash selector dial on position O – all the lights are off and programme is selected, the message Err is displayed three flashing dashes will be displayed.
-
Page 11: Programme Information
13 START/PAUSE button At the same time an alarm code appears on the display. E10 = the machine does not fill E20 = the machine does not empty E40 = the door has not been closed To eliminate the problem, see paragraph “Something not working”. -
Page 12: Washing Hints
D = Delicate spin 60° and 40° These programmes have to be used for lightly or Separate short spin at the maximum speed 700 rpm normally soiled cotton and synthetic items. The for hand washed garments. It has to be used for washing time will reduced only by few minutes. -
Page 13: Removing Stains
Removing stains may be used in this appliance: – powder detergents for all types of fabric, Stubborn stains may not be removed by just water – powder detergents for delicate fabrics (60°C max) and detergent. It is therefore advisable to treat them and woollens, prior to washing. -
Page 14: Operating Sequence
: the corresponding light comes on. 3. Measure out the additive EWS 1021 EWS 1221 If required, pour fabric softener into the compartment marked , without exceeding the «MAX» mark. 7. Select the required options The light corresponding to the depressed button 4. -
Page 15: Interrupting A Programme
10. Changing an option or a programme during its cycle It is possible to change any option before the programme carries it out. Before you make any change, you must pause the washing machine by pressing the START/PAUSE button. Changing a running programme is possible only by resetting it. -
Page 16: International Wash Code Symbols
International wash code symbols These symbols appear on fabric labels, in order to help you choose the best way to treat your laundry. Energetic wash Max. wash Max. wash Max. wash Max. wash temperature temperature temperature temperature 95°C 60°C 40°C 30°C Hand wash Do not... -
Page 17: Washing Programmes
Programme chart Washing programmes Consumption* Programme Additional Max. Temp. Type of fabric description functions load Energy Water Time min. 60°- 95° White Wash at 60°-95°C 4,5 kg 60° cottons 3 rinses Normal spin White cotton Wash at 60°C 4,5 kg 0.85 60°... -
Page 18: Special Programmes
Programme chart Special programmes Consumption* Selector dial Programme Additional Max. Programme position description functions load Energy Water Time min. Rinses 3 rinses with liquid 4,5 kg 0.05 additives if required Long spin For emptying out the Drain last rinse of the programmes with options Drain and long spin... -
Page 19: Maintenance
Maintenance Detergent can also accumulate inside the drawer Bodywork recess: clean it with an old toothbrush. Refit the Clean the outside of the machine with soap and drawer after cleaning. water only. Rinse with clean water and dry with a soft cloth. -
Page 20: Water Inlet Filter
• Remove any objects from the pump impeller by Emergency emptying out rotating it. If the water is not discharged, proceed as follows to empty out the machine: • pull out the plug from the power socket; • close the water tap; •... -
Page 21: Something Not Working
Something not working? Problems which you can resolve yourself. During machine operation it is possible that one of the following alarm codes appears on the display and at the same time the light , starts to flash: - E10 : problem with the water supply - E20 : problem with water draining - E40 : door open Once the problem has been eliminated, press the START/PAUSE button to restart the programme. -
Page 22: The Door Will Not Open
Problem Possible cause • The door will not open: • The programme is still running. • The door lock has not yet released. • The water level is above the bottom edge of the door. • The machine is heating the water. •... - Page 23 The Electrolux Group. The world’s No.1 choice. The Electrolux Group is the world’s largest producer of powered appliances for kitchen, cleaning and outdoor use. More than 55 million Electrolux Group products (such as refrigerators, cookers, vacuum cleaners, chain saws and lawn mowers) are sold each year to a value of approx.14 billion USD in more than 150 countries around the world.